Fisher & Paykel 590241 Manuel d'utilisateur

1 F9 Diagnostic Manual DishDrawer™ Ph5 & 6 590241

10 Check the resistance between pin 3 & 4 for the detergent diverter coil, The following resistances should apply: 65 Ohms (+/- 10 Ohms) If shor

11 Check the drying fan: This can be checked on harness P203 on pins 3 & 4, it is not possible to check the resistance so you should only replac

12 Check the Water Softener: If fitted, check the water softener coils, these can be checked at harness P202 Remove the water softener harness

13 Check for Corrosion or Burning at the Controller Connections: Check connections and check the secondary touch panel switches, to do this you will

14 For integrated models check the length of the door panel, that this has not been extended and is covering the fan duct, which will cause a buil

15 Check the Chassis board: Check the chassis board (mains filter board) for any corroded/ burnt contacts or dry joints, to do this remove the mains

16 5 DIAGNOSTICS 5.1 DishDrawer Diagnostics DishDrawer™ diagnostics can only be entered in Power Off mode, i.e. when there is no display on the LCD,

17 5.1.2 Hardware Output Test Mode – Level Two This level tests all the hardware outputs and inputs. The LCD display shows ‘HO’ Pre Finished

18 LCD Norm Fast Deli Rinse Hardware Output ------------------------------------------------------------------------------------------- bL Off

19 Once the fast test cycle is selected, the DishDrawer™ goes into standby mode and 8 minutes will be showing on the display. The test cycle is star

2 Brand: Fisher & Paykel DCS MODELS MARKETS DD605/DS605 NZ, AU, UK, EU, DK, US,CA DD60 NZ, AU, UK,EU, DK, DD90 NZ, AU, UK,EU,DK

20 6 WIRING DIAGRAM

3 CONTENTS 1 FAULT FINDING PROCEDURE ... 4 2 F9 FAULT CODE...

4 1 FAULT FINDING PROCEDURE Before beginning, determine if the controller fitted is a PH5 or PH5.1 controller, as the fault finding procedure is sl

5 2 F9 FAULT CODE Display Secondary Panel Power Supply / Controller Fault The product will disable power supply, log the fault, lock out the us

6 4 CHECKING SPECIFIC COMPONENTS Device Connector Pin Pair Description Fill valve P205 10 & 11 65 +/- 10 ohm Lid motor P205 6 &

7 Motor phases P201 1 & 2 8.0 +/- 5 Ohms (per winding), 16 ohms phase to phase from the controller connector Dropper resistor P101 4 &a

8 4.1 Component Checking Procedure Number Procedure Check Dropper Resistor: This is checked at the power connector harness at the controller (P101)

9 Check the lid actuators: These are checked at the chassis harness (P205) between pins 6 & 7, 8 & 9. Normal resistance range may vary, s