Fisher & Paykel CG604 Manuel d'utilisateur télécharger pdf (Page 10)

– 2

Installation instructions

Gas inlet pipe

Fastening the installation brackets (fig. 4)

Each cooktop is provided with an installation kit including brackets and screws for fastening

the top to fixture panels from 2 to 4 cm thick.

Turn the cooktop upside down and fasten the brackets “F and R” to the appropriate socket

holes, without tightening the screws “B” for the moment.

Make sure that the brackets are fastened as shown in figure 4.

Fastening the cooktop (fig. 4)

Spread the sealing material “C” out along the fixture hole, making sure that the junctions

overlap at the corners.

Insert the cook top into the hole and position it correctly.

Adjust the position of the brackets “F and R” and tighten screws “B” to block the cooker top

firmly in position.

With a sharp cutter or trimmer knife trim the excess sealing material around the edge of the

cooktop.

Fig. 4

Rear side

Front side

20 mm min.

40 mm min.

20 mm min.

40 mm min.

FRONT

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Pas de commentaire

Fisher & Paykel CG604 Manuel d'utilisateur Page 10